Description

In general, the Notifier NMM-100P Mini Monitor Module can be install in a single-gang junction directly behind the monitored unit. Besides, its small size and light weight allow it to be install without rigid mounting. The NMM-100P(A) is intend for use in intelligent, two-wire systems where the individual address of each module is selected using rotary switches. It provides a two wire initiating device circuit for normally-open-contact fire alarm and security devices. NMM-100P(A).

Use to monitor a single device or a zone of four-wire smoke detectors, manual fire alarm pull stations, waterflow devices, or other normally-open dry-contact devices. May also be use to monitor normally-open supervisory devices with special supervisory indication at the control panel. Monitored circuit/device is wire as an NFPA Style B (Class B) Initiating Device Circuit. A 47K Ohm End-of-Line Resistor (provided) terminates the circuit.

Furthermore, each Notifier NMM-100P uses one of the available module addresses on an SLC loop. Also, it responds to regular polls from the control panel and reports its type and the status (open/ normal/short) of its Initiating Device Circuit (IDC).

Notifier NMM-100P(A) is a miniature monitor module a mere 1.3″ (3.302 cm) H x 2.75″ (6.985 cm) W x 0.65″ (1.651 cm) D that supervises a Style B (Class B) circuit of dry-contact input devices. Its compact design allows the NMM-100P(A) to be mount in a single-gang box behind the device it monitors.

• Download the Specification sheet in *.pdf format